HIKVISION 8 Port Fast Ethernet Smart POE Switch – DS-3E1310P-EI/M

• 8 × 10/100 Mbps PoE ports,2 × Gigabit RJ45 port
• Total PoE Power Budget 60 W
• Support 802.1Q VLAN
• Support PoE watchdog to detect and restart the cameras that do not respond
• Support STP/RSTP Loop prevention
• Support cable detection to locate failure
• Up to 300 m Long Range PoE Transmission
• 6 kV Surge Protection

THÔNG SỐ KỸ THUẬT

• General
• ShellMetal material
• Net Weight0.54 kg (1.19 lb)
• Gross Weight1.08 kg (2.38 lb)
• Dimensions (W × H × D)217.6 mm × 27.6 mm × 108.5 mm (8.57” × 1.09” × 4.27”)
• Operating Temperature0 °C to 40 °C (32 °F to 104 °F)
• Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
• Operating Humidity5% to 95% (no condensation)
• Relative Humidity5% to 95% (no condensation)
• Power SupplyDC54 V,1.2 A
• Installation ModeDesk-Mounted,Wall-Mounted
• Max. Power Consumption65 W
• Power Consumption in Idle5 W
• Surge Protection6 kV
• Network Parameters
• Các cổng8 × 10/100 Mbps PoE port,2 × Gigabit RJ45 port
• MAC Address Table4 K
• Switching CapacityWhole-Device Performance: 9.6 GbpsPort Performance: 5.6 Gbps
• Packet Forwarding RateWhole-Device Performance: 7.14 MppsPort Performance: 4.17 Mpps
• Internal Cache2 Mbits
• PoE Power Supply
• PoE StandardIEEE 802.3af,IEEE 802.3at
• PoE Power PinEnd-span: 1/2(-), 3/6(+)
• PoE PortPoE: Ports 1 to 8
• Max. Port Power30 W
• PoE Power Budget60 W

• Software Function
• Long RangePorts 1 to 8: up to 300 m.Long range performance may vary depend on camera model or cable condition.
• Port IsolationPorts 1 to 8: port isolation mode to improve network securityPorts in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
• PoE WatchdogPorts 1 to 8: auto detect and restart the cameras that do not respond.
• Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.Support 802.1D STP.Suppport 802.1w RSTP.
• VLANVLAN is used for network scale planning and network health improvement.Support 802.1Q.Configurable VLAN ID from 1-4094.Support Trunk, Access port mode.Support Max. 4094 VLAN.
• HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported:1. Display the port rate.2. Display the port bandwidth utilization rate.3. Display the PoE power usage.4. Display topology information.5. Display the alarm status.6. Restart ports and devices.7. Enable port long-rage mode.8. Remotely upgrade the device.
• System MaintenanceSupport device management via web.Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.Support management via Hik-Central Pro.Support remote management via Hik-Partner Pro. Support cable detection. Supports 802.1ab LLDP for peer device discovery.Support port mirroring for fault locating.

• Approval
• EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
• SafetyCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
• ChemistryCE-RoHS (2011/65/EU); WEEE (2012/19/EU); Reach (Regulation (EC) No.1907/2006)