HIKVISION 8 Port Fast Ethernet Smart POE Switch – DS-3E1309P-EI

8 Port Fast Ethernet Smart POE Switch

• 8 × 100 Mbps PoE RJ45 ports, 1 × gigabit network RJ45 port.

• PoE ports chuẩn  IEEE 802.3at/af

• Hỗ trợ quản lý sơ đồ mạng, cảnh báo, giám sát qua APP Hik-Partner Pro

• Công suất 1 port: 30W

• Tổng công suất: 110W

• Switching capacity: 3.6 Gbps

• Packet forwarding rate: 2.6784 Mpps

• Internal cache: 4 Mbits Hỗ trợ PoE watchdog tự động phát hiện và khởi động lại port bị treo

• Chống sốc điện lên đến 6 KV Nguồn sử dụng: 48 VDC, 2.5 A

THÔNG SỐ KỸ THUẬT

• General
• ShellMetal material, fan-free design
• Net Weight0.35 kg (0.77 lb)
• Gross Weight1.114 kg (2.45 lb)
• Dimensions (W × H × D)170.00 mm × 27.60 mm × 93.10 mm (6.69” × 1.09” × 3.67”)
• Operating Temperature0 °C to 40 °C (32 °F to 104 °F)
• Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
• Operating Humidity5% to 95% (no condensation)
• Relative Humidity5% to 95% (no condensation)
• Power Supply54VDC，2.22A
• Installation ModeDesk-Mounted,Wall-Mounted
• Max. Power Consumption120 W
• Power Consumption in Idle10 W
• Surge Protection6 kV

• Network Parameters
• Ports8 × 10/100 Mbps PoE port,1 × Gigabit RJ45 port
• MAC Address Table8 K
• Packet Forwarding RateWhole-Device Performance: 4.17 MppsPort Performance: 2.68 Mpps
• Internal Cache4 Mbits
• Switching CapacityWhole-Device Performance: 5.6 GbpsPort Performance: 3.6 Gbps

• PoE Power Supply
• PoE StandardIEEE 802.3af,IEEE 802.3at
• PoE Power PinEnd-span: 1/2(-), 3/6(+)
• PoE PortPoE: Ports 1 to 8
• Max. Port Power30 W
• PoE Power Budget110 W

• Software Function
• Long RangePorts 1 to 8: up to 300 m.Long range performance may vary depend on camera model or cable condition.
• Port IsolationPorts 1 to 8: port isolation mode to improve network securityPorts in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
• PoE WatchdogPorts 1 to 8: auto detect and restart the cameras that do not respond.
• Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.Support 802.1D STP.Suppport 802.1w RSTP.
• VLANVLAN is used for network scale planning and network health improvement.Support 802.1Q.Configurable VLAN ID from 1-4094.Support Trunk, Access port mode.Support Max. 4094 VLAN.
• HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported:1. Display the port rate.2. Display the port bandwidth utilization rate.3. Display the PoE power usage.4. Display topology information.5. Display the alarm status.6. Restart ports and devices.7. Enable port long-rage mode.8. Remotely upgrade the device.
• System MaintenanceSupport device management via web.Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.Support management via Hik-Central Pro.Support remote management via Hik-Partner Pro.Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.Supports 802.1ab LLDP for peer device discovery.Support port mirroring for fault locating.

• Approval
• EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020),IC (ICES-003: Issue 7:2020),RCM (AS/NZS CISPR 32: 2015)
• SafetyCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
• ChemistryCE-RoHS (2011/65/EU),WEEE (2012/19/EU),Reach (Regulation (EC) No.1907/2006)