HIKVISION 24 Port Gigabit Smart POE Switch – DS-3E1526P-EI/M

• 24 x gigabit PoE RJ45 ports, 1 × gigabit RJ45 port, 1 x gigabit fiber optical port
• Total PoE power budget 230 W
• Unified cloud management for security systems
• Network topology at your fingertips
• Remote troubleshooting
• Visualized topology management
• Up to 300 m long-range PoE transmission
• 6 kV surge protection

THÔNG SỐ KỸ THUẬT

• General
• ShellMetal material
• Net Weight2.96 kg (6.52 lb)
• Gross Weight3.2 kg (7.05 lb)
• Dimensions (W × H × D)440.0 mm × 220.8 mm × 44.0 mm (17.32” × 8.69” × 1.73”)
• Operating Temperature0 °C to 45 °C (0 °F to 113 °F)
• Storage Temperature-40 °C to 85 °C (-40 °F to 185 °F)
• Operating Humidity5% to 95% (no condensation)
• Relative Humidity5% to 95% (no condensation)
• Power Supply100~240 VAC, 50/60 Hz, Max. 4 A
• Installation ModeRack (equipped with mounting ears)
• Max. Power Consumption250 W
• Power Consumption in Idle30 W
• Surge Protection6 KV

• Network Parameters
• Ports24 × Gigabit PoE port,1 × Gigabit RJ45 port,1 × Gigabit fiber optical port
• MAC Address Table8 K
• Switching Capacity56 Gbps
• Packet Forwarding Rate41.66 Mpps
• Internal Cache4.1 Mbits

• PoE Power Supply
• PoE StandardIEEE 802.3af,IEEE 802.3at
• PoE Power Pin8-pin power: 1/2(-), 3/6(+), 4/5(+), 7/8(-)
• PoE PortPoE: Ports 1 to 24
• Max. Port Power30 W
• PoE Power Budget230 W

• Software Function
• Long RangePorts 1 to 24: up to 300 m.Long range performance may vary depend on camera model or cable condition.
• Port IsolationPorts 1 to 24: port isolation mode to improve network security.Ports in an isolation group cannot communicate with each other, but they can communicate with ports outside the isolation group.
• PoE WatchdogPorts 1  to 24: auto detect and restart the cameras that do not respond.
• Link AggregationLink aggregation is used to aggregate multiple physical ports to form a logical port for load balancing, bandwidth expansion, and port protection.Support static link aggregation.Support 8 aggregation groups.
• Loop PreventionLoop prevention is used to prevent the switching network from forming loops, which will seriously affect network communication. Disabled by default.Support 802.1D STP.Suppport 802.1w RSTP.
• VLANVLAN is used for network scale planning and network health improvement.Support 802.1Q.Configurable VLAN ID from 1-4094.Support Trunk, Access port mode.Support Max. 32 VLAN.
• HPPSupport one-click activation and remote management via Hik-Partner Pro. Functions supported:1. Display the port rate.2. Display the port bandwidth utilization rate.3. Display the PoE power usage.4. Display topology information.5. Display the alarm status.6. Restart ports and devices.7. Enable port long-rage mode.8. Remotely upgrade the device.
• System MaintenanceSupport device management via web.Support DHCP Client. Enabled by default for dynamic assignment of management IP addresses.Support Super IP, which is a fixed IP address (10.180.190.200) for direct access.Support remote management via Hik-Partner Pro.Support cable detection. Abnormal open circuits and short circuits as well as network cable length can be detected.Support 802.1ab LLDP for peer device discovery.Support port mirroring for fault locating.
• Approval
• EMCCE-EMC (EN 55032: 2015+A11: 2020, EN IEC 61000-3-2: 2019, EN 61000-3-3: 2013+A1: 2019, EN 50130-4: 2011+A1: 2014, EN 55035: 2017+A11: 2020)
• SafetyCB (AMD1:2009, AMD2:2013, IEC 62368-1: 2014 (Second Edition), CE-LVD (EN 62368-1: 2014+A11: 2017)
• ChemistryCE-RoHS (201165EU); WEEE (201219EU); Reach (Regulation (EC) No.19072006)